mc68000 startup with monitor
Posted: Wed Jan 31, 2024 4:37 pm
Hi,
I would like to start the system into the monitor code. This would require to remove the second pair of Eprom. A second question is, if I would like to implement System II (I'm owner of such a system), should I create a new item? Btw. the board was published in MC Magazine, but it was developed by the VCS Company.
regards
Uwe
I would like to start the system into the monitor code. This would require to remove the second pair of Eprom. A second question is, if I would like to implement System II (I'm owner of such a system), should I create a new item? Btw. the board was published in MC Magazine, but it was developed by the VCS Company.
regards
Uwe