Dual AimTrak Lightguns
I'm trying to get my AimTrak light guns assigned per Ultimarc's instructions, and am having difficulties. My MAME directory is V:\MAME. I saved my controller setup file there along side the mame.ini file. When I go into MAME to assign the light guns (and corresponding joystick for the side buttons), they are either 3 or 4. Not the 1 and 2 that are assigned in ctrl config file. It's like it sees that 1 and 2 are already used, and it assigns 3 and 4. I'm not sure if it's always 3 and 4, but it's never 1 and 2.
- Attachments
-
- MARemapControls.png (24.02 KiB) Viewed 16112 times
-
- mameini.png (20.89 KiB) Viewed 16112 times
-
- light gun 2.png (7.99 KiB) Viewed 16112 times
-
- light gun 1.png (7.43 KiB) Viewed 16112 times
Re: Dual AimTrak Lightguns
For this specific question, you may get better/more response on the following forum than over here :Tommy714 wrote: ↑Wed Sep 25, 2024 2:08 am I'm trying to get my AimTrak light guns assigned per Ultimarc's instructions, and am having difficulties. My MAME directory is V:\MAME. I saved my controller setup file there along side the mame.ini file. When I go into MAME to assign the light guns (and corresponding joystick for the side buttons), they are either 3 or 4. Not the 1 and 2 that are assigned in ctrl config file. It's like it sees that 1 and 2 are already used, and it assigns 3 and 4. I'm not sure if it's always 3 and 4, but it's never 1 and 2.
https://www.mameworld.info/ubbthreads/p ... d=ultimarc